Management software in the "Smart Access Point Pro"
System Manual 2CKA001473B5074
│108
2. Select the "Emergency card" setting [1].
3. Open the "Emergency card" function [2].
Fig. 95: Set up the "Electronic cylindrical lock"
4. Select the desired transponder key in the list [1].
– All transponder keys that are stored via the authentication in the system are shown in
the list, see chapter 5.5.3 “Add authentication“ on page 138.
– The emergency function can be set up for every listed transponder key. This turns the
transponder key into an emergency card.
5. Confirm the selection.
– The emergency function for the transponder key has been set up.
– The selected "Electronic cylindrical lock" can be opened with this emergency card even
during a non-existing radio connection to the "Smart Access Point Pro".
5.3.4
Add "RF/IP Gateway"
To add a "RF/IP Gateway", perform the following steps: