Commissioning
System Manual 2CKA001473B5074
│32
3.2
Prerequisites
„Electronic cylindrical lock“
■
Every reading head must have a radio connection to the "Smart Access Point Pro" during
commissioning.
– This radio connection can be established directly or indirectly via other devices.
– The connecting path to their later area of application must be specified in the
management software of the "Smart Access Point Pro" prior to the installation of the
devices.
■
All "Electronic cylindrical lock" can be commissioned together locally. For this all devices of
the system must be located in close proximity to the "Smart Access Point Pro". After the
joint commissioning, the devices are then mounted at their area of application.
■
If additional devices are required for the application of the "Electronic cylindrical lock"
("RF/IP Gateway" or "RF Repeater"), they should have already been put into operation for
the commissioning of the "Electronic cylindrical lock".
"Smart Access Point Pro"
A "Smart Access Point Pro" is required for the application of the "ABB-AccessControl" system.
