Commissioning
System Manual 2CKA001473B5074
│33
3.1
Commissioning of the system - "Smart Access Point Pro"
3.1.1
Overview
Commissioning of the "Smart Access Point Pro" system is carried out in 3 sections.
– Please observe the order of the steps. They are dependent on each other.
1.
Connect the "Smart Access Point Pro" via WLAN with
a computer any call up the website of the "Smart
Access Point Pro".
see chapter 3.1.2 “Connecting a PC with
the "Smart Access Point ““ on page 33
2.
Make a preliminary decision about the system mode.
see chapter 3.1.3 “Preliminary information:
Selection of the system mode“ on page 35
3.
Run through the wizard with selection of the system
mode.
see chapter 3.1.4 “Commissioning the
"Smart Access Point"“ on page 36
3.1.2
Connecting a PC with the "Smart Access Point “
Attention! Loss of data
The "Smart Access Point" safely integrates the device found into the system with
the aid of certificates. This makes encrypted communication between all devices
possible.
■
Perform a backup after commissioning.
– If the Smart Access Point becomes defective, without a backup you
would need to re-commission the entire system.
Connecting the "Smart Access Point" with the PC via WLAN
P E
o
Fig. 19: Connecting the "Smart Access Point" with the PC (Access-Point mode)
As soon as the "Smart Access Point" is supplied with voltage via the PoE switch, the device
boots up automatically.
The device is in Access-Point mode (the LED lights up permanently red).