230
ACS510 User’s Manual
Technical Data
Analog Cables
Recommendations for analog signal runs:
• Use double shielded, twisted pair cable.
• Use one individually shielded pair for each signal.
• Do not use a common return for different analog signals.
Digital Cables
Recommendation for digital signal runs: A double shielded cable is the best
alternative, but single-shielded, twisted, multi-pair cable is also usable.
Control Panel Cable
If the control panel is connected to the drive with a cable, use only Category 5 Patch
ethernet cable. The maximum length that is tested to meet EMC specifications is 3 m
(9.8 ft). Longer cables are susceptible to electromagnetic noise and must be user-
tested to verify that EMC requirements are met. Where long runs are required
(especially for runs longer than about 12 m (40 ft)), use a RS232/RS485 converter at
each end and run RS485 cable.
Drive’s Control Connection Terminals
The following table provides specifications for the drive’s control terminals
Efficiency
Approximately 98% at nominal power level.
Cooling
Air Flow, 380…480 V Drives
The following table lists heat loss and air flow data for 380…480 Volt drives.
Frame Size
Control
Maximum Wire Size
Torque
mm
2
AWG
Nm
lb-ft
All
1.5
16
0.4
0.3
Cooling Specifications
Method
Internal fan, flow direction from bottom to top.
Requirement
Free space above and below the ACS510 drive: 200 mm (8 in).
Free space is not required on the drive’s sides – ACS510 drives can be mounted
side-by-side.
Drive
Heat Loss
Air Flow
ACS510-01-
Frame Size
W
BTU/hr
m
3
/h
ft
3
/min
-03A3-4
R1
40
137
44
26
-04A1-4
R1
52
178
44
26
Supplied from China by: Guangzhou Tofee Electro Mechanical Equipment Co., Ltd
Email: info@tofee.com.cn
