Fieldbus control through a fieldbus adapter 411
The references are scaled as defined by parameters
…
; which scaling is
in use depends on the setting of
and
.
The scaled references are shown by parameters
and
.
Actual values
Actual values are 16-bit words containing information on the operation of the drive.
The types of the monitored signals are selected by parameters
and
Debugging the network words
If parameter
, the actual values sent to the
fieldbus are displayed by
and
.
Scaling of actual values
Note:
The scalings described below are for the ABB Drives communication profile.
Fieldbus-specific communication profiles may use different scalings. For more
information, see the manual of the fieldbus adapter.
The actual values are scaled as defined by parameters
; which scaling
is in use depends on the setting of parameters
.
(with speed reference)
(with frequency reference)
0
-20000
20000
Drive
Fieldbus
0 (with torque or power reference)
±(
) (with speed reference)
) (with frequency reference)
10000
-10000
(with torque reference)
(with power reference)
-(
) (with speed reference)
-(
) (with frequency reference)
-(
) (with torque reference)
-(
) (with power reference)
Summary of Contents for ACS860
