Parameters 123
Speed ref ramp in
(page
).
10
Speed ref ramped
(page
).
11
Speed ref used
).
12
Torq ref used
(page
).
13
Freq ref used
).
14
Source selection (see
on page
).
-
Defines the real value of the signal (selected by parameter
) that corresponds to the minimum value of
frequency output 1 (defined by parameter
0.000
-32768.000 …
32767.000
Real signal value corresponding to minimum value of
frequency output 1.
1 = 1
Defines the real value of the signal (selected by parameter
) that corresponds to the maximum value of
frequency output 1 (defined by parameter
). See parameter
.
1500.000;
1800.000
(
b0)
-32768.000 …
32767.000
Real signal value corresponding to maximum value of
frequency output 1.
1 = 1
Defines the minimum value of frequency output 1. See
diagrams at parameter
.
0 Hz
0…16000 Hz
Minimum value of frequency output 1.
1 = 1 Hz
No.
Name/Value
Description
Def
/
FbEq16
Signal
(real)
selected by
par.
Signal
(real)
selected by
par.
f
out
)
f
out
)
Summary of Contents for ACS860
