Guidelines for planning electrical installation 35
4
Guidelines for planning
electrical installation
Contents of this chapter
This chapter contains instructions on selecting, placing and protecting the DC/DC
converter circuit components and cables.
Limitation of liability
The installation must always be designed and made according to applicable local laws and
regulations. ABB does not assume any liability whatsoever for any installation which
breaches the local laws and/or other regulations. Furthermore, if the recommendations
given by ABB are not followed, the drive may experience problems that the warranty does
not cover.
Generic guidelines
See
Electrical planning instructions for ACS880 multidrive cabinets and modules
(3AUA0000102324 [English]) for the generic guidelines for planning the electrical
installation (selecting cables, routing cables, etc.) of the air-cooled multidrive cabinets.
Summary of Contents for ACS880-1607
