66 Start-up
Disconnecting the DC/DC converter with DC
switch/disconnector (F286)
Tasks
Safety
WARNING!
Only qualified electricians are allowed to carry out the work described in this
chapter. Read the complete safety instructions in
Safety instructions for ACS880 multidrive
cabinets and modules
(3AUA0000102301 [English])
.
Ignoring the instructions can cause
physical injury or death, or damage to the equipment.
Stopping the DC/DC converter
Stop the converter unit. See
DC/DC converter control program firmware manual
(3AXD50000024671 [English]).
Disconnecting the energy storage
Open the contactor of the energy storage.
Open the disconnector of the energy storage. Lock out and tag out. The load disconnected indicator
[P13.x] is lit.
Disconnecting the DC/DC converter
Open the DC switch/disconnector ([Q11], F286). Lock out and tag out. The DC/DC converter
disconnected indicator [P12.x] is lit.
Working inside the DC/DC converter cubicle
If you need to work inside the DC/DC converter cubicle, you must switch off and disconnect the
whole multidrive system from any (AC, DC, main or auxiliary) power sources. Obey the instructions
of
.
Summary of Contents for ACS880-1607
