ABB ACS880-17 Hardware Manual Download

Page: 183 / 244

Technical data 183

Package

Standard package:

• timber, polyethylene sheet (thickness 0.2 mm), stretch film (thickness

0.023 mm), PP tape, PET strap, sheet metal (steel)

• for land and air transport when planned storage time is less than 2 months or

when storage can be arranged in clean and dry conditions less than 6 months

• can be used when products will not be exposed to corrosive atmosphere

during transport or storage

Container package:

• timber, VCI sheet film (PE, thickness 0.15 mm), VCI stretch film (PE,

thickness 0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)

• for sea transport in containers
• recommended for land and air transport when storage time prior to installation

exceeds 6 months or storage is arranged in partially weather-protected
conditions

Seaworthy package:

• timber, plywood, VCI sheet film (PE, thickness 0.15 mm), VCI stretch film (PE,

thickness 0.04 mm), VCI emitter bags, PP tape, PET strap, sheet metal (steel)

• for sea transport with or without containerization
• for long storage periods in environments where roofed and humidity-

controlled storage cannot be arranged

Cabinets are fastened to the pallet with screws and braced from the top end to
the package walls to prevents swaying inside the package. Package elements
are attached together with screws. For handling the packages, see section

Moving and unpacking the drive

on page

Disposal

The main parts of the drive can be recycled to preserve natural resources and
energy. Product parts and materials should be dismantled and separated.
Generally all metals, such as steel, aluminum, copper and its alloys, and
precious metals can be recycled as material. Plastics, rubber, cardboard and
other packaging material can be used in energy recovery. Printed circuit boards
and DC capacitors (C1-1 to C1-x) need selective treatment according to
IEC 62635 guidelines. To aid recycling, plastic parts are marked with an
approppriate identification code.
Contact your local ABB distributor for further information on environmental
aspects and recycling instructions for professional recyclers. End of life
treatment must follow international and local regulations.

Applicable standards

The drive complies with the standards below. The compliance with the European
Low Voltage Directive is verified according to standard EN 61800-5-1.

EN 61800-5-1:2007

Adjustable speed electrical power drive systems. Part 5-1: Safety requirements
– electrical, thermal and energy

EN 60204-1:2006 +A1
2009

Safety of machinery. Electrical equipment of machines. Part 1: General
requirements. Provisions for compliance: The final assembler of the machine is
responsible for installing emergency-stop device.

IEC/EN 60529:1991 + A1
2000

Degrees of protection provided by enclosures (IP code)

EN 61800-3:2004

Adjustable speed electrical power drive systems. Part 3: EMC requirements and
specific test methods

UL 501:2007

Enclosures for Electrical Equipment, Non-Environmental Considerations

UL 508C:2002

UL Standard for Safety, Power Conversion Equipment, third edition

UL 508A: 2001

UL Standard for Industrial Control Panels, first edition

CSA C22.2 No. 14-10

Industrial control equipment