Parameters and firmware blocks
106
-8…8
Scaling factor for speed reference 1/2.
24.07
SPEEDREF NEG ENA
FW block:
(see above)
Selects the source for the speed reference inversion. 1 = Sign of the speed reference is changed
(inversion active).
Bit pointer: Group, index and bit
24.08
CONST SPEED
FW block:
(see above)
Defines the constant speed.
-30000…30000 rpm
Constant speed.
24.09
CONST SPEED ENA
FW block:
(see above)
Selects the source for enabling the use of the constant speed reference define by parameter
. 1 = Enable.
Bit pointer: Group, index and bit
24.10
SPEED REF JOG1
FW block:
(see above)
Defines the speed reference for jogging function 1. See section
-30000…30000 rpm
Speed reference for jogging 1.
24.11
SPEED REF JOG2
FW block:
(see above)
Defines the speed reference for jogging function 2. See section
-30000…30000 rpm
Speed reference for jogging 2.
24.12
SPEED REFMIN ABS
FW block:
(see above)
Defines the absolute minimum limit for the speed reference.
0…30000 rpm
Absolute minimum limit for speed reference.
Limited speed reference
Speed reference
Summary of Contents for ACSM1 Series
