Parameters and firmware blocks
149
Group
Basic settings for fieldbus communication. See also chapter
on page
50
50 FIELDBUS
Firmware block:
FIELDBUS
(50)
This block
• initialises the fieldbus
communication
• selects communication supervision
method
• defines scaling of the fieldbus
references and actual values
• selects sources for programmable
status word bits
• shows the fieldbus control and
status words, and references.
Block outputs located in other
parameter groups
(page
)
(page
)
(page
(page
50.01
FBA ENABLE
(see above)
Enables communication between the drive and fieldbus adapter.
(0)
DISABLE
No communication.
(1)
ENABLE
Communication between drive and fieldbus adapter enabled.
50.02
COMM LOSS FUNC
(see above)
Selects how the drive reacts in a fieldbus communication break. The time delay is defined by
parameter
.
(0)
NO
Protection inactive.
(1)
FAULT
Protection active. The drive generates alarm FIELDBUS COMM and
sets the speed to the value defined by parameter
WARNING
! Make sure that it is safe to continue operation in
case of a communication break.
(2)
SPD REF SAFE
Protection is active.
FIELDBUS
36
TLF9 500 μsec
(1)
50.01 FBA ENABLE
[ Disable ]
50.02 COMM LOSS FUNC
[ No ]
50.03 COMM LOSS T OUT
[ 0.3 s ]
50.04 FBA REF1 MODESEL
[ Speed ]
50.05 FBA REF2 MODESEL
[ Position ]
< 50.06 FBA ACT1 TR SRC
[ SPEED ACT ]
(7 / 1.01)
< 50.07 FBA ACT2 TR SRC
[ TORQUE ]
(1 / 1.06)
< 50.08 FBA SW B12 SRC
[ FALSE ]
< 50.09 FBA SW B13 SRC
[ FALSE ]
< 50.10 FBA SW B14 SRC
[ FALSE ]
< 50.11 FBA SW B15 SRC
[ FALSE ]
2.12 FBA MAIN CW
2.13 FBA MAIN SW
2.14 FBA MAIN REF1
2.15 FBA MAIN REF2
Summary of Contents for ACSM1 Series
