Fault tracing
207
2042
D2D CONFIG
(0x7583)
The settings of drive-to-drive
link configuration parameters
(group
) are incompatible.
Check the settings of the parameters in group
.
2047
SPEED FEEDBACK
(0x8480)
No speed feedback is received.
Check the settings of the parameters in group
Check encoder installation. See the
description of fault
(ENCODER1) for
more information.
2048
OPTION COMM LOSS
(0x7000)
Communication between drive
and option module (FEN-xx
and/or FIO-xx) is lost.
Check that option modules are properly
connected to Slot 1 and (or) Slot 2.
Check that option modules or Slot 1/2
connectors are not damaged. To determine
whether module or connector is damaged:
Test each module individually in Slot 1 and
Slot 2.
Code
Alarm
(fieldbus code)
Cause
What to do
Summary of Contents for ACSM1 Series
