AquaMaster 3 FET200
Electromagnetic flowmeter Transmitter
3 Electrical Installation
16
OI/FET200–EN Rev. I
3.2 Connections
3.2.1 AquaMaster3 Sensor Connections (Remote or Close-Coupled only)
Referring to Fig. 3.4:
1.
Remove the screwed cap
A
on the sensor connector.
2.
Gently push the sensor plug
B
into the socket and rotate it until it engages, then tighten the locking
ring.
3.2.2 Using Tamper-Detection Seals
Referring to Fig. 3.5:
1.
Pass the wire of the seal through both the hole in the locking-ring and the matching hole in the front
of the transmitter.
2.
Close the seal.
Note.
Refer to Section Fig. 3.4, page 22 for MODBUS connection.
Note.
If the sensor cable is terminated with fly leads, connection is via a sensor cable adapter box
(part number WABC2035 available separately).
Fig. 3.4 Sensor Connections
Fig. 3.5 Using Tamper-Detection Seals
A
B
Security Tag and Seal
