4.
Set the parameters under
Serial settings
,
Protocols
,
Framing
,
Exceptions
, as
the network and the Modbus master and slaves require.
See Chapter Common parameters for additional information and
recommendations.
The parameters under
Network server settings
are not used in
the “Serial master to network slaves” mode.
5.
In the
Routes to client/slaves
tab, set the route parameters.
See Chapter Route parameters for additional information and recommendations.
6.
Click
Submit
to save the settings.
7.
Restart the device.
9.3.2
Configuring the network master to serial slaves mode
1.
In the left pane, under
Serial Port and I/O
, click
Modbus Gateway (RSx)
.
2.
Set
Enable Modbus gateway
to
Yes
.
3.
Set
Gateway mode
to
Network master to serial slaves
.
4.
Set the parameters under
Serial settings
,
Protocols
,
Framing
,
Exceptions
and
Network server settings
as the network and the Modbus master and slaves
require.
See Chapter Common parameters for additional information and
recommendations.
5.
Click
Submit
to save the settings.
6.
Restart the device.
9.4
Parameter settings
9.4.1
Parameter types
The parameters are divided into two groups.
•
Common parameters
•
Route parameters
Common parameters define for example the protocols used in serial and network
communications, serial port settings and protocol specific timeouts. Route parameters
are only required in the "Serial master to network slaves" mode defining the IP and
Modbus addresses of slaves behind the network.
Section 9
1MRS758460 B
Modbus application settings
36
ARG600 Dual SIM Variant
User Manual
