ABB ATS Annunciator, Quick Start Manual

8

—

Information

—
MODBUS Device IDs

Each device on a MODBUS Network must have a unique ID.
Non-unique IDs cause communications conflicts and must be resolved. See Troubleshooting.

ATS IDs are set in the ATS MODBUS interface.
Annunciator IDs are set via the ATS Annunciator Tool (Step 6).

—
Factory reset

Factory default settings are Annunciator ID=1 (         in Step 6) in and no configured ATS (          in Step 6 all “None”).
Press and hold Factory Reset and Firmware Update switch until the Status LED turns red (5 seconds) -          in figure in Step 4.
The Status LED will be green when Reset is complete.

—
Firmware Update

1. Download the Remote Upgrade Program to the PC - See Reference Documents.
2. Press and release Factory Reset and Firmware Update switch until the Status LED turns red (5 seconds) -          in figure in    

Step 4. The Status LED will blink red.

3. Run the Remote Upgrade Program on the PC.

a.  Establish communications with the Annunciator.
b.  Follow instructions as presented by the Remote Upgrade Program.                                                                                                     
   The Status LED will be green when upgrade is complete. 
   It may be necessary to press and release S2 to exit the programming mode.

2.

4.

2.

2.