Configuration
62
Power Panel FT50 User's manual V1.19
7.1.1.4 Service page
Screen
On this service page, some settings for the display can be changed. The following graphic shows the default
settings:
Startup
Network
Time
Screen
Audio
Gesture
VNC
Web
Storage
Update
Backup & Reset
Display brightness
0 to 100%
50
Screensaver
Screen rotation
Specify the screen rotation angle
0°
Boot animation left pos
Animation offset from left side in pixels
0
Boot animation top pos
Animation offset from top in pixels
0
Boot animation delay
Boot animation delay in ms
0
Display brightness
Default setting: 50
Input range: 0 to 100
Unit: %
Here, the current brightness of the display and the basic setting for the display are set after restarting the device:
•
Each change to a value on the service page directly and immediately affects the brightness of the display.
•
The currently set value is only stored as the default setting for the device when saved (see
).
Setting 0% on the service page corresponds to a residual brightness of 20%:
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
100%
0
10
20
30
40
50
60
70
80
90
100
Range from 0 to 50
Range from 50 to 100
Brightness range of the display
Setting range on the service page screen
The brightness can also be controlled by the application (see
"Adjusting display brightness" on page 86
).
Screensaver
Default setting: Disabled
Options for the enabled screensaver are described in section
"Screensaver settings" on page 63
.
Screen rotation
Default setting: 0°
Input range: 0°, 90°, 180°, 270° (in 90° steps)
The angle of rotation of the display is set here. This setting affects how screen content is output. After selection,
the display content is rotated clockwise according to the specified angle.
