Configuration
Power Panel FT50 User's manual V1.19
63
Settings for the boot animation
These settings are used to configure the position and time delay for the boot animation:
Boot animation left pos
Default setting
0
Input range
0 to 2048
1)
Unit
Pixels
Function
Defines the distance from an existing boot animation to the left edge of the display.
Boot animation top pos
Default setting
0
Input range
0 to 2048
1)
Unit
Pixels
Function
Defines the distance from an existing boot animation to the top edge of the display.
Boot animation delay
Default setting
0
Input range
0 to 1000
Unit
ms (milliseconds)
Function
Delay in milliseconds between individual images in the GIF animation. The individual values have
the following effect:
Value [ms]
Description
0
In this case, the delay defined in the GIF file will be used.
If no delay is defined in the GIF file, 100 ms is used.
>0
Applies the set delay time.
It may not be possible to achieve small values due to the power limits of the device. In this case, the
animation is displayed slower than the value specified.
Boot animation requirements/information
1)
Reasonable values range from 0 to the width/height of the screen. The screen width/height depends on the used device and the configured
Screen rotation
.
7.1.1.4.1 Screensaver settings
If option
Screensaver
is enabled, additional options are displayed:
Startup
Network
Time
Screen
Audio
Gesture
VNC
Web
Display brightness
0 to 100%
50
Screensaver
✓
Start screensaver after
1 to 60 minutes
15
Screensaver type
Backlight off
Screen rotation
Start screensaver after
Default setting: 15
Input range: 1 to 60
Unit: Minutes
If there is no touch screen activity for the specified duration, the screensaver is started. Touching the screen exits
the screensaver and the last active screen contents are shown.
Screensaver type
Default setting: Backlight off
If the screensaver is started after a period of inactivity, the display goes into the selected mode:
Black
The display is dark. The backlight remains on.
Backlight off
The display is dark. The backlight is switched off (result: lower power consumption).
