Configuration
Power Panel FT50 User's manual V1.19
81
7.2 Update
Information:
It is important to note that a special accessory cable is necessary to be able to connect USB acces-
"FT50 PoE cable - M22/RJ45, USB" on page 33
In principle, it is possible to connect a USB hub. The operation of several USB devices is only possible
to a limited extent, however. It is important to connect only one USB flash drive. A mouse and keyboard
can be operated simultaneously.
When updating the Power Panel with a USB flash drive, it is important to note that the drive must have a capacity of
at least 256 MB. In addition, an industrial-grade USB flash drive must be used (see
).
7.2.1 Updating with Automation Studio and USB flash drive
Upgrade PPT Image in Automation Studio
USB memory
Automation Studio
Power Panel
1
3
4
5
2
1. Update the PPT image for the Power Panel in Automation Studio (upgrade).
2. Configure the Power Panel in Automation Studio according to requirements.
3. Connect a USB flash drive to the computer and select the following menu command in Automation Studio:
°
Project / Project installation / Generate project installation package
The corresponding device (Power Panel) must be selected in the following selection dialog box. After con-
firming the selection, the target medium (connected USB flash drive) is selected and the process is started
using button [
Download to application memory
].