Connection and installation
Product manual 2CKA001373B8563
│18
5.4
Mounting
Once you have connected all cables for the electrical connection and the connection to the
busline, mount the device in the flush-mounted box.
To install the device, perform the following steps:
1
2
Fig. 7:
Installation position of flush-mounted insert
[1] Insert the flush-mounted insert into the flush-mounted box.
– Pay attention to the correct installation position.
– Orientate yourself on the " TOP" marking.
[2] Screw the flush-mounted insert in place.
– Use the provided screws.
Fig. 8:
Fitting the front cover
[3] Place the front cover on the lower edge of the flush-mounted insert.
[4] Push the anti-theft device (clip) about halfway into the provided shaft.
– Pay attention to the correct orientation of the clip.
– When the clip is pushed in about halfway, the front cover can snap into place.
3
4
5