ABB ABILITY™ SMART SENSOR BLUETOOTH® GATEWAY
DOCUMENT ID
REV.
DATE
LANG.
PAGE
9AKK107046A4620
L
August 2022
EN
11/29
© Copyright 2021 ABB. All rights reserved.
2.3.2
Network configuration – Firmware 2.1.0
The values in the first section of the
Basic page
are similar to firmware 1.4.3, but with
some extra options that the newer firmware brings:
-
Router Mode:
AC Managed Router
-
Tx Power:
20
-
Statistics Report Interval:
5 minutes
-
AC Server Address:
gw.smartsensor.abb.com
-
AC Server Address for China:
gw.smartsensor.abb.com.cn
-
AC-Router Protocol Priority:
MQTT
-
Enable OAuth2 Token For Local API:
OFF
-
Remote Assistance:
ON
Connection Priority
in 2.1.0 firmware is similar to firmware 1.4.3, only the naming of the
three connection types have changed:
-
Wired
for PoE and LAN connections.
-
Wi-Fi
for WIFI connection.
-
Cellular
for mobile USB dongle connection.
If
Cellular
connection is used, the option
Recovery Action
must be set to
ON.
This option enables the gateway to attempt a
reboot
of the 3G dongle when it is not
being able to provide a network connection anymore.
If all the information has been filled as shown above and the
Wired
,
Wi-Fi
or
Cellular
sec-
tions are configured according to your
network specifications
, please refer to
to check if the connection has been successfully set-up.
!
!
