ABB COMMANDER 1900 Series, User Manual

6

…2

CONTROL CONFIGURATION LEVEL

•

Ramp/Soak

2.2

Ramp/Soak Profile Control

In this Section, parameters in the lower display denoted 

■

 are Company Standard Settings. The instrument is dispatched

programmed with these settings.

Active

Inactive

Run

PrOFLE
CONtrL

SELECt

  NONE

CtrL 1

PrOFLE

r–h.Src

  NONE

SEG 99

run.Src

HLd.Src

SKIP–F

    ON

SEG 99

  NONE

  NONE

CtrL 2

   OFF

t–UNIt
  MINS
 HOUrS

OFF

SEG 99

  NONE

SEG 99

SKIP–b

  NONE

SEG 99

NONE

Page Header – Profile Control.

To advance to the 

Profile Program

 page press the 

 switch.

Select Controller
Select the Controller to be programmed:

CtrL 1

–

Controller 1

CtrL 2

–

Controller 2 (if fitted)

NONE

–

No controller selected

Ramp/Soak Profile Enable
If 

ON

 is selected, Profile Control is enabled and the 

Profile States Page

 is displayed in the

OPERATOR LEVEL

. If 

OFF

 is selected Profile Control is disabled and the 

Profile States Page

 is

omitted from the 

OPERATOR LEVEL

.

Program Time Units
Select the time units required:

MINS

–

Minutes

HOUrS

–

Hours

The time base selected applies to all segments.

Program Run/Hold Source
Select the source required to activate program run/hold. The run/hold source is level triggered i.e.
the active logic state must be maintained to select the alternative function.

If a program is activated or placed into operator hold mode
using 

Program Run/Hold Source

, the 

Program Run Source

and 

Program Hold Source

 have no effect.

For description of sources for this and subsequent source frames, refer to table 2.1 on page 10.

Program Run Source
Select the source required to run or restart a program. The run source is leading edge
triggered i.e. the active logic state can be removed after the
function is selected.

Program Hold Source
Select the source required to place the program running into operator hold mode. The hold
source is leading edge triggered.

The program is restarted using the 

Program Run Source.

Segment Skip Forward Source
Select the source required to skip to the next segment. If the segment running is the last segment
of the program, the set point advances to the last set point value of the segment and stops the
program.  The skip source is leading edge triggered.

Segment Skip Backward Source
Select the source required to skip back to the beginning of the ramp/soak segment running. The
skip source is leading edge triggered.

Continued on next page.

Active

Inactive

Run

Hold