Chapter 2 - Start-Up Instructions
IV F
2 - 6
DCS 600 Operating Instructions
Symbols for switching the electronics or the power section ON and OFF
El
- Switch
ON
electronics (El)
- Switch
ON
contactor, i.e.
the unit will be connected
to the supply
(
POWER ON
)
Control Panel key:
(when in LOCAL mode)
El
- Switch
OFF
electronics (El)
- Switch
OFF
contactor, i.e.
the unit will be discon-
nected from the supply
(
POWER OFF
)
Control Panel key:
(when in LOCAL mode)
Symbols for enabling / disabling the reference
- ENABLE reference, i.e.
START
DRIVE
Control Panel key:
(when in LOCAL mode)
- DISABLE reference, i.e.
STOP
DRIVE
Control Panel key:
(when in LOCAL mode)
System-dependent planning
During normal operation the control commands like
SWITCH
ON
and
SWITCH
OFF
,
ENABLE
etc. will be preset by APC2 or fieldbus adapter. These Operating Instructions
only describe the start-up procedure via panel CDP 312 when in LOCAL mode or/and
via PC program DRIVES WINDOW.
During the start-up procedure a suitable possibility for safe shutdown (switching OFF)
will be required if there is a wrong setting of parameters. In most cases it will not be
sufficient to allow an operation of EMERGENCY STOP (EME-STOP) with a ramp
function!
Symbol for altering parameters
Enter at keyboard (with
Parameter Mode [PAR])
e.g. 15.05 = 3
Assign the value of 3 to
Parameter 15.05
Symbol for displaying parameter values
Display
Symbol for measuring physical variables
Measure
