ABB E-Hub 2.0, Getting Started

11

E - H U B 2 .0  

G E T T I N G  S TA R T ED

Tick on the "Sniff gratuitous ARP packets" box.
Digit in the device IP address of E-Hub 2.0, and 
click on plus symbol. Digit for each device 
connected via Modbus TCP the device static IP 
address and click on plus symbol.
Otherwise, input the IP address range where to 
scan those devices. In the slave address drop-
down menu, it is possible to select the addresses 
of the slaves connected with Modbus RTU 
communication protocol.

Then press “OK”
Select “Start Discovery”.

Once the E-Hub 2.0 module has been found, digit 
the 16 character password code that you can find 
printed on the left side of the devices and press 
“Let me in”.

With Automatic discovery, Ekip Connect will scan 
the whole Modbus network looking for devices to 
provision.

With Manual discovery, it is possible either to 
provide the list of specific Modbus RTU or IP 
addresses or to narrow the scan to a particular 
range of addresses.

The Manual discovery is recommended: in the
new Page select “Manual Discovery settings”