14.5 FlexLoader Vision Lite configuration
Configuration file
Introduction
The instructions below are for integrators, ABB’s own technicians and for
information. The customer usually does not need to edit this configuration.
The instructions below assume knowledge of the general setup of ABB’s system
and handling of XML files.
For operation of FlexLoader Vision Lite, the file
FlexLoaderVisionLite.xml
file must
be configured. If an external operator panel is used, this file must be available for
both FlexLoader Vision and MasterHandler.
Basic data
Specify whether the overlap between the gripper fingers is to be checked or not.
Also specify whether the lathe has a sub-spindle or not.
Indicate for each option if it is used or not. The options are: air cleaning box, wash
box, marking unit, statistical outlet, deburr, actions and special program for robot.
If marking is to be used, the maximum mark text lengths for small, medium and
large must also be specified. These are connected to the mark data files that are
used in the marker machine.
There is also the option to activate up to eight numeric values, which can be used
freely for anything and will be stored with the detail. Similarly, there are up to eight
Continues on next page
242
Product manual - FlexLoader Vision
3HAC051771-001 Revision: B
© Copyright 2014-2018 ABB. All rights reserved.
14 FlexLoader Vision Lite
14.5 FlexLoader Vision Lite configuration
Summary of Contents for FlexLoader Vision
