Power Break® II Devices
Draw-Out Device Installation
Installing the Device
Use the following procedure to install the draw-out device
into the substructure.
Attach the Lifting Bar, catalog number TDOLB, by
locating the hooks on the bar beneath the shoulder
studs of the device, as illustrated in Figures 4 and 5.
Pull out the substructure rails until they drop into the
horizontal locked position. Lower the device so that the
grooves in the rollers drop over the rails.
Make sure the grooves in all rollers straddle the rails, as
illustrated in Figure 6, then remove the Lifting Bar and
push the device into the substructure until it stops in the
DISCONNECTED position. Then lift the rails and push
them in to the stored position.
CAUTION:
The device must be
OFF before it is connected.
If the device is charged, press the ON button to close the
device contacts, then press the OFF button to open
the contacts.
Engage the 1/2 - inch square end of the racking shaft
with the supplied wrench, catalog number TDORT, and
rotate the shaft clockwise to draw the device into the
TEST or CONNECTED position, as illustrated in Figure 7.
The compartment position indicator is shown in Figure
8.
NOTE:
If the device does not fit the structure, check the
rejection relationship, illustrated in Figure 8, to verify that a
correctly rated device is being installed. Table 1 lists the
correct draw-out substructure for each device frame.
NOTE:
Si le mécanisme ne rentre pas dans le berceau,
vérifier le détrompeur illustré dans les figure 8, qui
empêche l’insertion d’un mauvais calibre de mécanisme. La
Table 1 définis le berceau convenable à chaque taille de
mécanisme.
—
Figure 4. Lifting Bar attached to a draw-out device for manual lifting.
—
Figure 5. Lifting Bar attached to a draw-out device for lifting with a hoist.
Pipe
Lifting Bar
Shoulder
Stud
ATTENTION:
Le mécanisme doit être à OFF avant qu’il ne
soit embroché. Si le ressort de fermeture de mécanisme
est chargé, fermer les contacts de mécanisme par action
sur le bouton ON, puis appuyer sur le bouton OFF pour
ouvrir les contacts.
3
1.
2.
3.
4
.
