Power Break® II Devices
Draw-Out Device Installation
Removing the Device
Use the following procedure to remove the draw-out
device from the substructure.
CAUTION:
The device must be OFF before it is dis-
connected and removed.
ATTENTION:
Le mécanisme doit être à OFF avant qu’il
ne soit débroché et déposé.
Engage the 1/2 - inch square end of the racking shaft
with the supplied wrench, catalog number TDORT,
as illustrated in Figure 7, and rotate the shaft
counter-clockwise to withdraw the device to the
TEST or DISCONNECTED position. The compartment
position indicator is shown in Figure 8.
Pull the substructure rails out as far as possible until
they drop into the horizontal locked position, as
illustrated in Figure 9.
From the DISCONNECTED position, pull the device
out on the rails until the front rollers fall into the
detent, as illustrated in Figure 6.
The device can now be rotated about the front roller
by pulling forward, as illustrated in Figure 10, for
inspection of the rear of the device, or it can be
completely removed after attaching the Lifting Bar,
as illustrated in Figures 4 and 5.
—
Figure 9. Withdrawing the substructure rails.
—
Figure 10. Rotating the device forward for inspection.
5
1.
2
.
3
.
4
.
