Operation Manual / A150-M56/66/57/67 - A155-M..
2 Safety / 2.9 Lifting of loads
© Copyright 2021 ABB. All rights reserved.
HZTL4032_EN
Rev.R
August 2021
2.9
Lifting of loads
WARNING
Suspended loads
Loads that are not attached according to regulations can cause injury to
personnel or fatal accidents.
u
Loads must always be fastened to properly functional lifting gear with a
sufficient load limit.
u
Pay attention to the correct attachment of loads on the crane hook.
u
People must not stand beneath suspended loads.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Fig. 9: Attachment of loads on the crane hook
Fig. 10: Attachment angle
If there are two or more suspension points, the attachment angle of 45° must not be ex-
ceeded. This prevents excessive loading due to diagonal pull.
u
Before looping around the components of the turbocharger, let them cool down (max-
imum 80 °C).
u
Attach components of the turbocharger as described in the respective action steps.
u
Use a suitable edge guard if there are sharp edges.
u
The assembly devices must be completely screwed in and must not loosen during use.
u
Use assembly devices only for the described applications.
u
Put down dismantled components of the turbocharger in such a way that they cannot tip
over.
Page
20
/
198
Summary of Contents for HT606752
Page 2: ......
