Operation Manual / Power2 850-M / 4.1 Low-pressure stage
4 Disassembly and assembly / 4.1 Introduction
© Copyright 2020 ABB. All rights reserved.
HZTL4062_EN
Rev.C
July 2020
4
Disassembly and assembly
4.1
Introduction
WARNING
Non-observance of the work steps and further operations
Incorrectly performed work or further operations can cause injury to person-
nel or damage to the machine.
u
Only perform operations that are described in this document.
u
Only perform operations for which you have previously received instruc-
tion or training.
u
Have further operations carried out only by trained personnel from an
ABB Turbocharging Service Station.
u
Mark the casing position for assembly.
Tightening torques for components
The specified bolted connection tightening torques must be observed (see chapter
Tightening torques for assembly devices
Unless otherwise described, the screws and nuts of the assembly devices supplied by ABB
must be tightened in such a way that they are tight-fitting.
Page
8
/
43
