Operation Manual / Power2 850-M / 4.1 Low-pressure stage
2 Removal and installation / 2.3 Installing the low-pressure stage
© Copyright 2020 ABB. All rights reserved.
HZTL4062_EN
Rev.C
July 2020
2.3
Installing the low-pressure stage
Fig. 2: Suspension of complete low-pressure stage
u
Attach one lifting gear to each of the two bearing casing suspension points.
u
Check that the orifices specified for the low-pressure stage have been installed in both oil
supply lines.
u
Check that the gaskets have been correctly fitted at the oil inlet and the oil outlet in the
bracket.
u
Align the low-pressure stage on the engine.
u
Tighten the fixing elements on the foot according to the instructions of the engineb-
uilder.
u
Attach all gas, air, water and oil pipes in accordance with the instructions of the engineb-
uilder.
u
Connect the cable connector to the speed sensor.
u
Fit insulation according to the instructions of the enginebuilder.
Page
5
/
43
