Operation Manual / TPL76-C32/-C33/-C34/-C35
8 Disassembly and assembly / 8.8 Dismantling and fitting nozzle ring
at turbine end
© Copyright 2021 . All rights reserved.
HZTL2485_EN
Rev.G
July 2021
u
Bend up the locking plates (56018), undo nuts (56022) and remove.
u
Pull out nozzle ring.
u
Remove threaded stud (56021).
CAUTION
Fastening the nozzle ring
When fitting the nozzle ring, new threaded studs (56021), nuts (56022)
and locking plates (56018) from the customer spare part set (97070)
must be used.
CAUTION
Clogged areas on the nozzle ring
If a nozzle ring is clogged in some areas or is covered by loose parts, it
is recommended to appoint an ABB Turbocharging Service Station to
inspect the turbine blades and carry out a crack inspection.
Nozzle ring assembly
u
Carefully clean slots and contact surfaces of the casings and keep
them free of metal chips.
u
Keep slots and spiral-wound gasket free of oil and grease.
CAUTION
Fastening the nozzle ring
When fitting the nozzle ring, new threaded studs (56021), nuts (56022)
and locking plates (56018) from the customer spare part set (97070)
must be used.
Page
110
/
133