4.5.2
Clean the EVSE
Preliminary requirements
•
Cleaning agent. Refer to section
.
•
Non-abrasive tool. Refer to section
Danger:
Hazardous voltage
•
Do not apply high-pressure water jets. Water can leak into the EVSE.
Note: When the EVSE is put in a corrosion sensitive environment,
superficial rust is possible on welding points. This rust is only visual.
There is no risk for the integrity of the EVSE. The procedure below
removes the rust.
Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a a solution of cleaning agent to the surface and let it soak.
3. Manually remove dirt. Use the non-abrasive tool.
Caution: Do not use abrasive tools.
4. Rinse with low-pressure tap water.
5. If necessary, apply wax on the front for extra protection and gloss.
6. If there was rust and you want it not to appear again, apply a rust-preventive
primer. Ask the manufacturer for specifications and instructions.
4.5.3
Clean the contact dome
Preliminary requirements
•
Cleaning agent. Refer to section
.
•
Non-abrasive tool. Refer to section
•
Water repellent. Refer to section
.
Danger:
Hazardous voltage
•
Do not apply high-pressure water jets. Water can come into contact
with electrical connections.
Note: When the contact dome is put in a corrosion sensitive
environment, superficial rust is possible on welding points. This rust is
only visual. There is no risk for the integrity of the contact dome. The
procedure below removes the rust.
Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a a solution of cleaning agent to the surface and let it soak.
Operation
6AGA000007-0604-EN | 001
23
