ProcessMaster FEP610, HygienicMaster FEH610
| OI/FEP610/FEH610-EN Rev. B 11
The marking according to the Pressure Equipment Directive
(PED) can be found on the name plate.
Fig. 6:
PED marking (example)
1
CE mark (with number of labeled location)
2
Nominal size /
nominal pressure rating
3
Material (wetted parts)
4
Fluid group
resp. reason for the exception
5
Serial number of the flowmeter
sensor
The marking is applied depending to the nominal size
(> DN 25 or ≤ DN 25) of the flowmeter (also refer to Pressure
Equipment Directive 97/23/EC).
Pressure equipment subject to PED
Below the CE mark, the number of the designated authority to
confirm that the device meets the requirements of Pressure
Equipment Directive is specified.
The respective fluid group in accordance with the Pressure
Equipment Directive is indicated under PED.
Example: Fluid group 1 = hazardous fluids, gaseous.
Pressure equipment outside the applicable range of the
PED
Under PED, the reason for the exception in article 3,
paragraph 3 of the Pressure Equipment Directive is specified.
The pressure equipment is classified in the SEP (= Sound
Engineering Practice) "Good Engineering Practice" category.
G12005
1
4
5
2
3
