ABB i-bus
®
KNX
Parameters
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 298
7.12.1.2
Selection of Yes
7.12.1.2.1
—
Dependent Parameter
Maximum setpoint increase
Options:
0…3…5
This parameter determines the maximum adjustment that the analog control unit can make when
increasing the target temperature in Comfort mode. The Comfort value set cannot be increased by
more than this.
Note
The possible temperature adjustment range is from the center position of the rotary knob on the
analog room control unit all the way to the right. If the knob is as far to the right as possible, then
the increase is as high as possible (e.g. 3 K).
7.12.1.2.2
—
Dependent Parameter
Maximum setpoint reduction
Options:
0…3…5
This parameter determines the maximum adjustment that the analog control unit can make when
reducing the target temperature in Comfort mode. The Comfort value set cannot be reduced by
more than this.
Note
The possible temperature adjustment range is from the center position of the rotary knob on the
analog room control unit all the way to the left. If the knob is as far to the left as possible, the tem-
perature is reduced by the maximum (e.g. 3 K).
