ABB i-bus
®
KNX
Parameters
FCC/S 1.X.X.1 | 2CDC 508 200 D0211 Rev A 315
7.13.1.5.4
—
Dependent Parameter
Reaction on event X
The following apply to the
Reaction on event 0
and
Reaction on event 1
parameters.
Options:
No edge evaluation
On
Off
Toggle
End cyclic transmission
The standard value for
Reaction on event 1
is
On
. The standard value for
Reaction on event 0
is
Off
.
This determines how the group object reacts. If the
Distinction between long and short operation
parameter is set to
Yes
, the reaction occurs with a short or long operation. If it is set to
No
, it oc-
curs with each edge change.
Note
If it is set to
End cyclic transmission
, it is important to note that this is only effective if the
Send
status value
parameter is set to
On change and cyclically
.
