Connection, installation / mounting
KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905
│18
5.2
Mounting
NOTE
The device (with integrated bus coupler) has been prepared for installing in
flush-mounted boxes in connection with the enclosed support ring.
To install the device, perform the following steps:
1. Screw the support ring to the flush-
mounted box.
2. Attach the cover frame.
3. Pull the bus line out of the flush-
mounted box and connect the line to
the bus connection terminal [1], see
chapter 5.1 “Electrical connection“ on
page 17.
– Observe the correct polarity!