Description of application and parameters
Application "LED function"
KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905
│72
10.19
Application "LED function"
NOTE
The application is valid for the following parts of the device:
■
LED button 1
■
LED button 2
■
LED button 3
■
LED button 4
With the application "LED function", the LED of the button can be used for orientation
illumination, for status display or for function display. The LED can light up in different colours.
The LED can also flash for alarm display and/or scene storage display.
10.19.1 General parameters - "Operating mode"
Options:
Status illumination
Orientation illumination
The LED can serve either as a status display ("Status illumination") or orientation ("Orientation
illumination"). If the operating mode "Status illumination" is selected, the LED has its own
communication object "Status". This can either be a 1-bit or a 1-byte object (setting parameter
"Object type for status object"). When a telegram is received on the status object, the LED
changes colour. Which colour the LED takes on depends on the parameter settings "Colour for
Off/On".
If the operating mode "Orientation illumination" is selected, the colour of the LED does not
support the button function. The colour is specified via the "Colour of the orientation illumination"
parameter.
10.19.2 General parameters - Brightness of the colours
Options:
Dark
Bright
The LED can light up with two different brightness levels. The brightness can be set to "dark" or
"bright" via the "Brightness of the colours" parameter.