Description of application and parameters
Application "Temperature sensor"
KNX Technical Reference Manual 1473-1-8905 / 2CKA001473B8905
│86
10.22
Application "Temperature sensor"
NOTE
This application can be activated via "Temperature".
The device can be activated as temperature sensor. As such it serves as slave
device/temperature sensor for a room temperature controller which functions as master device.
Slave devices are to be linked to the master device with the appropriately labelled
communication objects. The slave device handles the room temperature control functions of the
master device.
10.22.1 General parameters - Sending measured values
Options:
Only cyclical
Cyclic and during change
The "Send measured values" parameter specifies whether the actual temperature is to be sent
out only cyclically if the actual temperature has also changed. However, it can also be specified
whether the actual temperature is always sent out in the interval in which the "Cycle time for the
sending of the actual temperature" parameter is set.
10.22.2 General parameters - Cycle time for sending of the actual temperature
Options:
00:00:25...01:30:00
The actual temperature is sent on the bus cyclically. The "Cycle time for sending the actual
temperature" parameter determines the interval after which a new sending out of the actual
temperature occurs.
10.22.3 General parameters - Temperature difference for sending within the cycle time *0.1 K
NOTE
This parameter is only visible if the "Send measured values" parameter is set on
"Cyclic and during change of value".
Options:
1..255