ABB i-bus
®
KNX
Safety
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 11
2
Safety
2.1
General safety instructions
►
Protect the device from moisture, dirt and damage during transport, storage and operation.
►
Operate the device only within the specified technical data.
►
Operate the device only in a closed housing (distribution board).
►
Mounting and installation must be carried out by qualified electricians.
►
Disconnect the device from the supply of electrical power before mounting.
2.2
Proper use
The device must be installed centrally in an electrical distribution board.
The device is a modular DIN rail component for quick installation in distribution boards on 35 mm mounting
rails according to EN 60715.
2.3
Cyber security (network security)
The industry is increasingly faced with cyber security risks. To increase the stability, security and
robustness of its solutions, ABB has introduced official robustness tests for Internet security as part of the
product development process.
In addition, the information below includes guidelines and mechanisms that you can use to improve the
security of KNX systems.
2.4
Preventing access to the different media
The basis for any protection concept is the careful shielding of the system against unauthorized access.
Only authorized persons (installers, janitors and users) should have physical access to a KNX system. The
critical points of every KNX medium must be protected as well as possible during planning and installation.
In general, applications and devices should be permanently installed to prevent their easy removal and in
this way prevent access to the KNX system for unauthorized persons. Sub-distributions with KNX devices
should be closed, or in rooms to which only authorized persons have access.
Summary of Contents for i-bus KNX AC/S 1.x.1 Series
