ABB i-bus
®
KNX
Parameters
212 2CDC508198D0211 Rev. A | AC/S 1.x.1
Object function
Name (can be changed
separately)
Data type
Flags
Input: Fan coil unit, fan speed confirm (slave)
Room
1 byte DPT 5.001
1 byte DPT 5.010
C, W, T, U
This group object is used for synchronization of the fan speed status between the Room ASM (slave) and the room thermostat
(master). For this purpose the group object must be connected to the controller's (master's) group object of the same name.
In this group object the room thermostat (master) confirms the change in the fan speed to the Room ASM (slave).
The data point type for the group object is dependent on the settings in the module:
•
If any option except
None
is selected for the
set (slave) DPT 5.001
option is
selected for the
parameter:
DPT 5.001
Telegram value 0…100 %
The fan speed in percent is transmitted, e.g. 50 %. Fan speeds are converted into the corresponding percentage.
•
If any option except
None
is selected for the
set (slave) DPT 5.010
option is
selected for the
parameter:
DPT 5.010
Telegram value 0 … 5
The fan speed is transmitted
Input: Fan coil unit, fan manual confirm (slave)
Room
1 bit
DPT 1.011
C, W, T, U
The module has this group object if any option except
None
is selected for the
parameter and the
set
(slave) DPT 5.001
option or
Set (Slave) DPT 5.010
option is selected for the
This group object is used for synchronization of the fan speed status between the Room ASM (slave) and the room thermostat
(master). For this purpose the group object must be connected to the controller's (master's) group object of the same name.
In this group object the room thermostat (master) confirms to the Room ASM (slave) whether the current fan speed has been
adjusted manually by a user or it was calculated automatically by the room thermostat.
Telegram value:
0 = Automatic
1 = Manual
Summary of Contents for i-bus KNX AC/S 1.x.1 Series
