ABB i-bus
®
KNX
Parameters
308 2CDC508198D0211 Rev. A | AC/S 1.x.1
Switch off if no room demand
Options:
No (checkbox cleared)
Yes (checkbox selected)
With this function the module monitors the room control values and automatically switches on and off the
heat generator connected accordingly.
It is a prerequisite for this function that all control values from the room valves in the heating system are
available and connected to the ASM input socket. There must therefore not be any conventional
thermostats in the heating system.
This function is affected by the
Enable heat generator based on ASM input socket
functions are activated, the
Enable heat generator based on ASM input socket
Selection of
Yes
option:
Dependent parameter(s)
Switch on if the room demand is higher than
Options:
0...10…100 %
The module sends a switch-on command to the heat generator if the highest room control value
present on the ASM input socket exceeds this value.
Switch off if the room demand is equal to or less than
Options:
0…100 %
The module sends a switch-off command to the heat generator if the highest room control value
present on the ASM input socket is the same as or less than this value.
Summary of Contents for i-bus KNX AC/S 1.x.1 Series
