ABB i-bus® KNX
PARAMETERS
7.4.109
Reset purge cycle from control value greater than or equal to
This parameter is used to define the control value as of which the purge cycle is reset.
More information: →
.
Option
1 … 99 %
Prerequisites for visibility
– Parameter
Options
Thermoelectric (PWM) / Open/close signal
– Parameter
\
Option
Automatic or via group object
• The parameter is in the parameter window
7.4.110
Send status values [analog room control unit]
This parameter is used to define when the value of the following group object is sent on the bus
(ABB i-bus® KNX):
•
Note
Sending on request can be triggered by the reception of a telegram with the value 0 or 1 on group ob-
ject
Option
After change
The value is sent if there is a change.
After change or cyclically
The value is sent after a change or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Prerequisites for visibility
\ Parameter
room control unit to physical device input a
\ Option
Yes
• The parameter is in the parameter window
.
7.4.111
Send status values [binary input]
This parameter is used to define when the value of the following group object is sent on the bus
(ABB i-bus® KNX):
•
Option
After change
The value is sent if there is a change.
After change or cyclically
The value is sent after a change or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
•
Prerequisites for visibility
\ Option
Binary input
• The parameter is in the parameter window
.
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B
119
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page
