ABB i-bus® KNX
PARAMETERS
7.4.114
Send status values [dew point alarm]
This parameter is used to define when the value of the following group object is sent on the bus
(ABB i-bus® KNX):
•
Note
Sending on request can be triggered by the reception of a telegram with the value 0 or 1 on group ob-
ject
Option
After change
The value is sent if there is a change.
After change or cyclically
The value is sent after a change or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Prerequisites for visibility
\ Option
Dew point
sensor
• The parameter is in the parameter window
.
7.4.115
Send status values [valve output]
This parameter is used to define when the values of the following group objects are sent on the bus
(ABB i-bus® KNX):
•
•
•
Note
Sending on request can be triggered by the reception of a telegram with the value 0 or 1 on group ob-
ject
Option
After change
The value is sent if there is a change.
Cyclically
The value is sent cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
On request
The value is sent on request.
After change or on request
The value is sent after a change or on request.
After change, on request or
cyclically
The value is sent after a change, on request or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Prerequisites for visibility
\ Parameter
\ Options
Thermoelectric (PWM)
/
Open/close signal
• The parameter is in the parameter window
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B
121
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page
