IM300 Intelligent Power Monitoring Instrument
49
energy at sharp,peak, shoulder or off-peak rate
They are used to setting the base value of the 3th quadrant total reactive energy
at sharp,peak, shoulder or off-peak rates. The top of the screen shows "Eq-3" type rate
were sharp, peak, shoulder, off-peak, the bottom right of the screen displays "kvarh"
expressed as reactive power, methods of operation and the display screen similar to
the thirty-sixth.
After completing all of the parameter settings, press
button to return to the
first screen.
3.4. Local Operation
In the single button mode, you can enter the local operation mode by pressing
“
” and “
” at the same time, “OPR” will display at the left top corner of the
screen.
Note
: In the local operation mode, press “
” and “
” will exit and go back to
the single button mode. If you don't press “
” to activate the page, press “
”
will turn to next screen. The screen will go back to the single button mode
automatically if there is no operation on buttons in ten minutes.
3.4.1. Local operation features
In local mode of operation can be performed:
Control the two relays output are opened or closed;
Clear SOE, clear power base, clear maximum demand;
Maximum electrical parameters of the minimum reset;
The alarm reset;
System reset operation.
3.4.2. Each local operation screen presentation
Starting interface for local operation mode password confirmation each time to
enter the local mode of operation are first prompted for a password, the password is
displayed as "----." Password total of four, ranging from 0000 to 9999, the factory
default value "0000." To enhance the confidentiality, is only display digital digit
Summary of Contents for IM300 Series
Page 1: ...IM300 Operational Manual ...
Page 109: ...CNABB CNIIB IM300 201903 REV C ...
