5.3 Cable harness
5.3.1 Replacing the cable package
Location of the cable package
The main cable package runs from the base, up through the swing, lower arm and
housing, and into the extender unit (only for IRB 1300-7/1.4 and IRB 1300-12/1.4)
and tubular.
The main cable package includes the air hoses and the cabling for all the six motors.
Optional Ethernet cabling can also be included.
The air hoses and optional Ethernet must be disconnected inside the tubular before
the cable package can be removed.
As standard feature, the connector interface is located at the rear of the base. The
interface can also be bottom mounted, as an option. This section describes both
configurations.
The cable packages are located as shown in the figures.
Bottom connector interface
Rear connector interface
Robot type
xx2000001261
xx2000001260
IRB 1300-
11/0.9
Continues on next page
148
Product manual - IRB 1300
3HAC070390-001 Revision: G
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the cable package
Summary of Contents for IRB 1300
