7.5 Standard toolkit
General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.
Contents, standard toolkit
Tool
Qty
Ring-open-end spanner 7-35mm
1
Socket head cap 3, 5, 8 mm
1
Torque wrench 4-33 Nm
1
Small screwdriver
1
Plastic mallet
1
Ratchet head for torque wrench 1/2
1
Cut-off pliers
1
90° angled bit holder
1
Spirit level
258
Product manual - IRB 360
3HAC030005-001 Revision: Z
© Copyright 2008-2021 ABB. All rights reserved.
7 Reference information
7.5 Standard toolkit
Summary of Contents for IRB 360
