2.4.3 Setting the system parameters for a suspended or tilted robot
General
The robot is configured for mounting parallel to the floor, without tilting, on delivery.
The method for mounting the robot in a suspended (upside down) or tilted position
is basically the same as for floor mounting, but the system parameters that describe
the mounting angle (how the robot is oriented relative to the gravity) must be
re-defined.
Note
With suspended installation, make sure that the gantry or corresponding structure
is rigid enough to prevent unacceptable vibrations and deflections, so that
optimum performance can be achieved.
Note
The allowed mounting positions are described in the product specification for
the robot. The requirements on the foundation are described in
.
System parameters
Note
The mounting angle must be configured correctly in the system parameters so
that the robot system can control the movements in the best possible way. An
incorrect definition of the mounting angle will result in:
•
Overloading the mechanical structure.
•
Lower path performance and path accuracy.
•
Some functions will not work properly, for example
Load Identification
and
Collision detection
.
Gravity Beta
If the robot is mounted upside down or tilted (rotated around the y-axis), then the
robot base frame and the system parameter
Gravity Beta
must be redefined.
Gravity
Beta
should then be π (+3.141593) if the robot is mounted upside down (suspended).
The
Gravity Beta
is a positive rotation direction around the y-axis in the base
coordinate system. The value is set in radians.
Continues on next page
Product manual - IRB 4600 Foundry Prime
65
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
2 Installation and commissioning
2.4.3 Setting the system parameters for a suspended or tilted robot
Summary of Contents for IRB 4600 Foundry Prime
