2.6 Installing options
2.6.1 Installing an expansion container
Validity of this section
This section is only valid for other design than Type C.
Introduction to the expansion container
The expansion container is needed on suspended robots (other design than Type
C) to make sure that the amount of oil in gearbox axis 1 covers all important parts.
Robots ordered as suspended robots have the expansion container installed on
delivery.
Expansion container
xx1000000318
Cover
A
Attachment screw M6x16, quality 8.8-A2F (5 pcs)
B
Oil expansion container with cover
C
Base
D
O-ring D220x5
E
Attachment screw M5x20, quality 8.8-A2F and washer (2+2 pcs)
F
O-ring D1=9.5 D2=1.6
G
Oil plug (to be removed)
H
Continues on next page
Product manual - IRB 4600 Foundry Prime
89
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
2 Installation and commissioning
2.6.1 Installing an expansion container
Summary of Contents for IRB 4600 Foundry Prime
