3 Maintenance
3.3.1. Inspection, oil level gearbox axis 1
3HAC023082-001 Revision: E
138
©
Co
py
rig
h
t 200
4-
200
8 ABB. All righ
ts reser
v
ed.
Inspection, oil level gearbox, axis 1
The procedure below details how to inspect the oil level in gearbox axis 1.
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
These procedures include
references to the tools required.
Equipment
Art. no.
Note
Action
Note
1.
WARNING!
Handling gearbox oil involves several safety
risks. Before proceeding, please observe the
safety information in section
risks during work with gearbox oil on page 41
.
2.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
3. Open the
oil plug, inspection.
Shown in the figure
!
4. Required oil level: max.10 mm below the oil plug
hole!
5. Add oil if required.
Art. no. is specified in
!
Further information about how to fill
the oil may be found in section
.
6. Refit the oil plug, inspection.
Tightening torque: 24 Nm.
7.
WARNING!
Do not mix the oil types! If wrong oil is refilled, the
gearbox must be rinsed as detailed in section
WARNING - Mixed oils may cause severe
damage to gearbox! on page 42
!
Continued
Summary of Contents for IRB 6600 - 175/2.8 type B
Page 2: ......
Page 10: ...Table of Contents 8 3HAC023082 001 Revision E Copyright 2004 2008 ABB All rights reserved ...
Page 532: ......