1 Safety
1.2.3.7. Work inside the robot's working range
27
3HAC026876-001 Revision: C
© Copyri
ght
200
6-2008 ABB.
All rights reserved.
1.2.3.7. Work inside the robot's working range
WARNING!
If work must be carried out within the robot’s work envelope, the following points must be
observed:
•
The operating mode selector on the controller must be in the manual mode position to
render the enabling device operative and to block operation from a computer link or
remote control panel.
•
The robot’s speed is limited to max. 250 mm/s when the operating mode selector is in
position "manual mode with reduced speed". This should be the normal position when
entering the working space. The position "manual mode with full speed (100%)" may
only be used by trained personnel who are aware of the risks that this entails.
•
Pay attention to the rotating axes of the robot! Keep a distance to the axes in order not
to get entangled with hair or clothing. Also be aware of any danger that may be caused
by rotating tools or other devices mounted on the robot or inside the cell.
•
Test the motor brake on each axis, according to section
