Removing the axis-5 motor
Use these procedures to remove the motor.
Preparations before removing the axis-5 motor
Note
Action
Decide which calibration routine to use,
and take actions accordingly prior to begin-
ning the repair procedure.
1
xx1200001005
Jog the robot to this position:
•
Axis 2: +25°
•
Axis 3: +35°
2
With the robot in this position, there is no
need to drain oil from the axis-5 gearbox
when the motor is replaced.
xx1400000719
Jog axis 4 to this position:
•
Axis 4: -90°
3
DANGER
Turn off all:
•
electric power supply
•
hydraulic pressure supply
•
air pressure supply
to the robot, before entering the robot
working area.
4
Continues on next page
556
Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.7.5 Replacing the axis-5 motor
Continued
Summary of Contents for IRB 6700 Series
